tag:blogger.com,1999:blog-6992065757008571272.post4498752764625653604..comments2024-03-19T08:44:39.879-07:00Comments on Altium Designer Blog: Ruminating Rigid Flex - Part 3Mikehttp://www.blogger.com/profile/04432112136897907705noreply@blogger.comBlogger1125tag:blogger.com,1999:blog-6992065757008571272.post-70141271545039635942013-10-10T06:41:39.444-07:002013-10-10T06:41:39.444-07:00Very nice article/blog! Also, on the tear relieve...Very nice article/blog! Also, on the tear relieve holes, sometimes folks put copper around the tear relief to provide additional support, particularly if that section of the board is going to be in a dynamice flex application. The copper provides additional strength against the start of a tear.Anonymoushttps://www.blogger.com/profile/14338020784289142122noreply@blogger.com